Echo 70487 - Manual (Page 4)

CRARY INDUSTRIES
237 NW 12th Street, West Fargo, ND 58078-0849
Phone: 701.282.5520 • Toll Free: 800.247.7335
Fax: 701.282.9522
E-mail: [email protected] • [email protected]
www.BearCatProducts.com
UNPLUGGING THE BLOWER
If the machine plugs, turn off the power source and 1.
make sure all moving parts have come to a complete
stop.
Remove the access cover (shown at right) and carefully 2.
clear out the debris.
If necessary, remove blower discharge tube and clear 3.
debris from tube.
Bolt access cover back in place. 4.
Test the machine. 5.
Remove access cover if machine plugs
SAFETY DECALS
The blower comes with the safety decals pictured below. Familiarize yourself with all of the safety and operating decals
on the machine and the associated hazards. Make certain that all safety and operational decals on this machine are
kept clean and in good condition. Decals that need replacement must be applied to their original locations.
PN 36176-00 PN 12174
IMPORTANT
Keep these instructions with your chipper/shredder
owner's manual as a reference.
PN 12174
DO NOT OPERATE MACHINE
WITHOUT SHIELDS IN PLACE.
FAILURE TO DO SO MAY CAUSE
SERIOUS INJURY OR DEATH.
DO NOT REMOVE CLEANOUT ACCESS COVER
UNLESS MACHINE IS STOPPED AND SPARK
PLUG WIRE OR DRIVE SHAFT IS DISCON-
NECTED. USE ACCESS FOR CLEANOUT OR
INSPECTION ONLY. DO NOT OPERATE MA-
CHINE WITH ACCESS COVER REMOVED.
ACCESS
COVER