Echo 70487 - Manual

Instruction Sheet
Instructions
PN 16087
Rev. 050409
SUBJECT: SINGLE SPEED
BLOWER ATTACHMENT (PN 70487)
FITS MODELS: SC5540 (70554)
AND SC5614 (71020)
Before inspecting or servicing any part of this machine,
shut off power source, remove key, disconnect the
battery cables and make sure all moving parts have
come to a complete stop.
WARNING
This kit adds a blower attachment to the 5" chipper/
shredders. The blower has a 360-degree rotatable
discharge chute and an adjustable deflector cap.
ASSEMBLY
Remove the rotor shaft end cap from the chipper. 1.
Remove one (1) 5/16 lock nut from discharge door 2.
rod, pull out rod and remove discharge door.
Install pulley, bushing and key onto rotor shaft. Do not 3.
tighten bushing bolts or set screw at this time.
Hold blower assembly up to frame, install new rod into 4.
frame and blower assembly and secure with 5/16"
lock nuts from kit. Slide bottom end of blower until it
fits against frame assembly. Make sure to hook the lip
of the blower to the lip on the chipper bottom.
Install belt onto the pulley that was just installed and 5.
onto the pulley on the blower assembly. The idler
pulley should run on the inside of the belt for correct
tension. Align pulleys to within 1/16".
Tighten bushing bolts in a clockwise direction and 6.
bushing set screw on rotor shaft pulley. Torque to
manufacturer's specifications.