IOGear GHD335C250 User Manual
Page 25
23
TRI-Select Button Management Software Introduction
The TRI-Select Button Management Software allows you to
configure each button for your custom backup sets as you
wish. The Button Management Software identifies each disk
for you by drive letter
1
and serial number
2
. When selected the
drive letter and serial number are red and you can begin con-
figuring the buttons. Each button is identified by the shape
that appears on it. The top button is the square
3
, the middle
button is the circle
4
and the bottom button is the triangle
5
.
Dantz Retropspect Express & TRI-Select Button Management Software
In the software you will see a box
6
next to each shape, this
is where the path to the selected backup script will be
displayed. To choose a backup script for that button you
want to click on the folder icon
7
below its box. If you ever
decide you no longer want that button active simply click
the red X
8
next to the folder icon and it will clear the box of
your selected path.
Whenever you have a drive connected you want the TRI-
Select Button Management Software active so be sure to
minimize rather than close it whenever you are done using
it. If you connect a new drive and want to configure its
buttons be sure to click the Refresh button
9
and the
software will scan for all new drives and list them as it finds
them.
1
2
3
4
5
9
6
8
7