beautypg.com

IOGear GCS1804 User Manual

Page 47

background image

46

47

Turn the power on the KVM. It is now set to the factory default firmware level.

3.

Leaving the jumper in place: Perform the firmware upgrade procedure again.

4.

When the upgrade procedure is complete, power off the switch, remove the jumper cap from J14,

5.

close the housing, and re-power the KVM.

Disassembly:
Remove the two screws on the bottom of the front panel.
Slide the panel forward, be careful, there are switch extender buttons on the port selector switches that
may fall off.
Remove the two bottom screws that hold the chassis to the case
Slide the unit out of the case.

To reassemble reverse the above procedure.
Note: Prior to tightening the front panel screws push the port selector buttons and listen for a for a “Click”
indicating the extenders are in their correct positions, then shake the unit gently to ensure there are no
loose items in side.

This manual is related to the following products: