BURY CP 1000 CarPhone USER Manual - Manual (Page 20)

20
Operating guidelines
Dial number
Delete group
Dial
Delete last
Delete all
Contacts
Play list
Dial number
It makes sense to divide telephone numbers in short number blocks of
3-4 digits and to say them this way. At each break, the BURY CP 1000
CarPhone repeats the number block and waits for the next number
block. After the signal tone you can respectively continue your an-
nouncement.
Enter the area code. Enter the first numbers of the actual telephone
number. Enter the remaining numbers of the actual telephone number.
When you have entered the last number block of the telephone number,
you can check the complete telephone number once again with the
voice command „PLAYBACK“. Here are some more commands:
The complete entry will be deleted, or the previous entry.
The last digit is deleted.
A telephone connection is being established.
The last number block will be deleted.
Contacts
The entire list is read aloud to you. With „STOP“ you can stop the
process and select the respective entry. With „NEXT“ or „NEXT
PAGE“ and „PREVIOUS“ or „PREVIOUS PAGE“ you can navigate in
the list. With „DIAL“ the telephone connection will be made. You can
also jump directly to one of the entries shown by activating the entry
number. E.g.: „SELECT ENTRY THREE“.
You can save names and phone numbers to the memory of the SIM
card (SIM directory) and to the internal memory of the car phone. De-
pending on your provider, up to 250 contacts can be stored to the SIM
card, while 1500 contacts can be stored to the internal memory.
You can also subsequently save a number that called your phone or
from which you received a text message. You do not have to enter the
number all over again.