I.R.I.S. IRIScan Pro 3 Wi-Fi Quick Start - Manual (Page 6)

Quick User Guide - English
6
Charge the Battery
The battery can be charged via the USB cable and via the USB power adapter.
1. Power off the scanner.
2. Connect the scanner to your computer using the USB cable.
3. Or connect the scanner to a power outlet by connecting the USB cable via the
USB power adapter.
4. When the battery is being charged, the green LED is solidly on. When the
charging is completed the LED is extinguished.
Time-out Settings
1. When using the scanner in SD mode -and not connected to a power source - the
scanner auto powers off after 5 minutes.
2. When using the scanner in SD mode - and connected to a power source - the
scanner never auto powers off.
3. When using the scanner in Wifi mode - and not connected to a power source - the
scanner never auto powers off.
Note however that Wifi mode consumes a lot of battery power. It is
recommended to deactivate Wifi mode when you are not using it.
4.2 Insert an SD Card
The scanner’s built-in storage disk has approximately 128MB of space that can be used
to store scanned images in SD mode. To extend its memory, insert an SD card.
1. Power off the scanner.
2. Insert the SD card gently into the card slot until the card is latched.
The position how the card must be inserted is shown in the image below and on
the scanner itself.