JLG 3248RS/10RS Operator Manual - Manual (Page 20)

SECTION 1 - SAFETY PRECAUTIONS
1-10 – JLG Lift – 3121272
• Always post a lookout when driving in areas where vision is
obstructed.
• Keep non-operating personnel at least 6 ft. (1.8m) away from
machine during all operations.
• Under all travel conditions, the operator must limit travel speed
according to conditions of ground surface, congestion, visibility,
slope, location of personnel, and other factors.
• Be aware of stopping distances in all drive speeds. When driving
in high speed, switch to low speed before stopping. Travel grades
in low speed only.
• Do not use high speed drive in restricted or close quarters or
when driving in reverse.
• Exercise extreme caution at all times to prevent obstacles from
striking or interfering with operating controls and persons in the
platform.
• Ensure that operators of other overhead and floor level machines
are aware of the aerial work platform’s presence. Disconnect
power to overhead cranes. Barricade floor area if necessary.
• Do not operate over ground personnel. Warn personnel not to
work, stand, or walk under a raised platform. Position barricades
on floor as necessary.