JLG 9MP Operator Manual - Manual (Page 25)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121162 – JLG Lift – 3-7
Platform Loading
The platform maximum rated load capacity is shown on a
decal located on the platform control panel and is based
on the following criteria.
NO PERSONNEL ARE ALLOWED ON THE MATERIAL TRAY.
Elevating/Lowering the Platform
IF THE FLOOR STOP IS NOT SET, THE PLATFORM WILL NOT ELE-
VATE. ELEVATE PLATFORM ONLY ON A FIRM, LEVEL AND UNI-
FORM SURFACE.
BEFORE AND WHILE ELEVATING THE PLATFORM, CHECK CLEAR-
ANCES ABOVE AND AROUND PLATFORM AND MAST TO ENSURE
ADEQUATE CLEARANCE.
ENSURE AREA BENEATH THE PLATFORM IS FREE OF PERSONNEL
AND OBSTRUCTIONS PRIOR TO LOWERING PLATFORM.
NOTE: An alarm and amber warning beacon mounted on
the front of the machine base frame will activate
when the platform is lowering.
MODEL 9MP -
MAXIMUM TOTAL PLATFORM CAPACITY - 500 lb. (230kg)
Location Load Capacity
1. Operator’s Compartment Operator + Tray Load Equal To
or Less Than Maximum Capacity
2. Material Loading Tray 250 lb. (115kg) - Maximum
Figure 3-4. Platform Load Capacity.
1
2
TO ELEVATE
PLATFORM
PRESS and HOLD
the FUNCTION
ENABLE button (2)
(GREEN), while
pressing the
PLATFORM UP
button (1)
(WHITE).
To STOP elevating
platform, release
either button.
TO LOWER
PLATFORM
PRESS and HOLD
the FUNCTION
ENABLE button (2)
(GREEN), while
pressing the
PLATFORM
DOWN
button (3)
(WHITE).
To STOP lowering
platform, release
either button.
1
2
3
2