JLG M4069 Operator Manual - Manual (Page 59)

SECTION 4 - MACHINE OPERATION
3121220 – JLG Lift – 4-5
4.9 SAFETY PROP
SAFETY PROP MUST BE USED WHEN MAINTENANCE REQUIRES SIZZOR ARMS
TO BE RAISED.
1. To engage safety prop, raise platform, pull ring to
release safety prop, then rotate prop clockwise until it
hangs vertically. Lower the platform until the safety
prop rests between the two extended cross-shafts.
2. To store safety prop, reverse operation of step 1.
4.10 BATTERY CHARGING PROCEDURE
The battery charger receptacle is located at the front of the
machine. The receptacle is located in the molded front panel.
1. Connect the charger receptacle to a 115 volt (220 volt)
power outlet with a 15 amp minimum capacity.
2. The batteries are charged fully when the 100% LED is
lit. At this time, the charger will shut off automatically.
NOTE: Discharged batteries will take approximately 23 hours to
charge.
4.11 TIE DOWN/LIFTING
Tie Down
1. Place platform in stowed position and retract deck
extension.
2. Remove all loose items from machine.
3. Secure the chassis using straps or chains of adequate
strength.
Lifting
NOTE: See manufacturer’s nameplate for gross weight of
machine as originally manufactured.
1. Place platform in stowed position and retract deck
extension.
2. Remove all loose items from machine.
3. Properly adjust rigging to prevent damage to machine
and so machine remains level.
NOTICE
DO NOT ATTEMPT TO LIFT MACHINE WITH A FORK TRUCK. FORK POCKETS
LOCATED UNDER BATTERY PACKS ARE PROVIDED FOR LIFTING BATTERIES
ONLY.