Traveling forward and reverse, 8 shut down and park, Traveling forward and reverse -4 – JLG M4069 Operator Manual User Manual
Page 58: Shut down and park -4
SECTION 4 - MACHINE OPERATION
4-4
– JLG Lift –
3121220
Traveling Forward and Reverse
1. At platform controls, pull out emergency stop switch
and select the drive switch.
2. Position drive controller to forward or reverse as
desired.
DIRECTION OF DRIVE AND STEER MOVEMENT MAY BE OPPOSITE FROM NOR-
MAL OPERATION. BEFORE DRIVING, LOCATE THE BLACK/WHITE ORIENTA-
TION ARROWS ON BOTH THE CHASSIS AND THE PLATFORM CONTROLS. MOVE
THE DRIVE CONTROLS IN A DIRECTION MATCHING THE ORIENTATION
ARROWS.
IF TILT ALARM IS ON WHEN PLATFORM IS RAISED, STOP DRIVING AND
LOWER PLATFORM COMPLETELY, THEN REPOSITION MACHINE SO THAT IT IS
LEVEL BEFORE RAISING PLATFORM.
4.8
SHUT DOWN AND PARK
NOTE:
When parking overnight, batteries should be charged
properly to ensure readiness for next workday.
To shut down and park the machine, the procedures are as fol-
lows:
1. Drive machine to a reasonably well protected area.
2. Ensure platform is fully lowered.
3. Push in the Emergency Stop at platform controls.
4. Push in the Emergency Stop at ground controls. Posi-
tion platform/ground select switch to center off.
5. If necessary, cover Platform Controls to protect
instruction placards, warning decals and operating
controls from hostile environment.
6. Chock at least two wheels when parking machine for
an extended period of time.
FWD
REV