Eppendorf Excella E-5 Classic Platform Shaker - Manual (Page 14)

Installation
New Brunswick Excella® E-5 Open Air Shaker
English (EN)
14
4.4 Selecting the location
Physical Location
It is essential that the instrument be situated in a area where there is sufficient space for the shaker and
platform to clear walls and obstructions during operation.
The surface on which the E-5 is placed must be smooth, level, and able to support the shaker under full
load operating conditions.
Operating Environment
The shaker is designed to operate optimally in the following ambient conditions:
• 5 – 45 °C
• 20 – 80 % Relative Humidity non-condensing
• Up to 2000 m
4.5 Electrical connections
Before making electrical connections, verify that the power source voltage matches the voltage on the
ELECTRICAL SPECIFICATION PLATE and that the ON/OFF SWITCH is on the OFF position. The
ELECTRICAL SPECIFICATION PLATE and the ON/OFF SWITCH are located on the rear panel (see
Fig. 3-1 on p. 9).
Description Part No. Quantity Application
10 – 24 × 5/16 in (7.9 mm)
flat Phillips head screw
S2116-3051 1 5/16 in (7.9 mm) thick
aluminum, phenolic and
stainless steel platforms.
The previous table also applies to 2800 ml Fernbach Flask Clamps.
WARNING!
 Do not position the equipment so that it is difficult to unplug from the mains/power.
CAUTION!
 A detachable main power cord has been provided with your unit. Only use the cord
provided and do not replace cord with an inadequately rated cord.