Eppendorf SmartBlock - Manual (Page 5)

5
Eppendorf SmartBlock — Instructions for use
When you attach the thermoblock, the device automatically recognizes the mounted
thermoblock. The ThermoMixer C limits the mixing frequency to the maximum value for
the thermoblock being used. The ThermoStat C limits the temperature to the maximum
value for the thermoblock being used.
4.1.1 Attaching the thermoblock
1. First only attach the rear edge of the thermoblock. The writing must face to the front.
2. Push the front edge of the thermoblock down.
•
The thermoblock audibly engages.
•
The display shows the name of the thermoblock.
4.1.2 Removing the thermoblock
WARNING!
WARNING! Risk of burns from hot surfaces.
The thermoblock and the heating/cooling plate can be very hot after heating
and cause burns.
 Allow the heated thermoblock and heating/cooling plate to cool down
completely before removing the thermoblock.
1. To unlock the thermoblock, press the
lever at the front of the thermoblock
down.
2. Lift the front edge so that the
thermoblock is tilted backwards.
3. Remove the thermoblock upwards.