IKA C-MAG HS 10 digital - Manual (Page 13)

­­13
CMAG dig 0511
Stirring organs
stirring bars: Ø 6 mm, lengts to 15mm
Ø 8 mm, lengts to 50mm
Ø10mm, lengt to 80mm
Any other accessories
RSE stirring bar remover
RS1 stirring bar set
H15 bath top
H28 bath top
H16V support rod
H38 holding rod
H44 cross sleeve
The support rod is attached using the thraeded support bore (H).
• Screw nut M10 on to the support rod as far as the stop
• Screw on the support rod as far as the stop by hand
• Tighten the support rod and nut M10 using a flat wrench
(SW17).
• Use bossheads to assemble accessory parts
or acces sory devices.
Accessories
17
H
The appliance is maintenance-free.
Cleaning
Only use cleansing agents which have been recommended by IKA.
Use to remove:
Dyes isopropyl alcohol
Construction materials water containing tenside/ isopropyl alcohol
Cosmetics
water containing tenside/ isopropyl alcohol
Foodstuffs water containing tenside
Fuels water containing tenside
- Do not allow moisture to get into the appliance when cleaning
- Wear protective gloves during cleaning the devices.
- Before using another than the recommended method for clean-
ing or decontamination, the user must ascertain with IKA that
this method does not destroy the instrument.
Ordering spare parts
When ordering spare parts, please give:
- Machine type
- Manufacturing number, see type plate
- Item number and designation of the spare part,
see www.ika.de
Repair
The device must be clean and free from any materials which may
constitute a health hazard when sent for repair.
Please return the appliance in its original packaging. Storage pack-
aging is not sufficient for returns. Please also use suitable packa-
ging for transportation.
Maintenance
Assembling the support rod