Aries Automotive 302505 - Manual (Page 2)

Page 2 of 2 5/3/2010
3. Slide (1) lock washers followed by (1) flat washer over each tow hook bolt, and with help slide
the tow hook bolts threw the back bumper followed by the spacers, ounce done lift the back
bumper up to the rear bumper of the car, proceed to then fasten the back bumper to the car.
Snug but do not tighten hardware at this time. (Fig 2 & Fig 2A) Shows bumper guard installed
to vehicle.
4. Align back bumper properly, and then tighten all hardware.
5. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Factory
Plastic hole
plugs
FIG 1
FIG 2A
451 Model shown
FIG 2
450 Model shown