Aries Automotive 25630 - Manual (Page 2)

5. Once lower part of bracket is attached measure from the lower cut edge up to the top cut edge
(distance apart) 3” as seen in (Fig 9) make sure top portion is aligned, once satisfied with position
& alignment mark holes through bracket for drilling (use a 3/8” size drill bit) to drill holes.
6. Once holes are drilled remove the previously install 8mm hardware (bottom) as we recommend
you spray paint the edge of the carrier pieces you cut earlier (these parts are aluminum and will
not rust but will be more pleasing to the eye if painted) once paint is dry attach the bottom bracket
with (4) 8mm hex bolts, (8) 8mm flat washers, (4) 8mm lock washers and (4) 8mm Hex nuts, as
seen in (Fig 10) Snug but do not tighten.
7. Attach the Upper portion of bracket to the lower lip of brake light with (4) 8mm hex bolts, (8) 8mm
flat washers, (4) 8mm lock washers and (4) 8mm Hex nuts, as seen in (Fig 10) Snug but do not
tighten.
8. Next reattach the tire carrier to the rear door with the factory (8) bolts; once all bolts are in place
tighten the factory bolts. With the carrier attached feed the brake light cable back through the door
pushing in the rubber plug and plug the wire harness back in, once done replace the plastic panel
back onto the doors inner panel, as seen in (Fig 3, 2 & 1).
9. With the door closed align the brake light assemblies so it holds the light strait up once satisfied
tighten all hardware. reattach the tire as seen in (Fig11)
Page 1 of 5 6/1/2012
Fig 1 Remove plastic
louvered cover Fig 2
Unplug rear 3 rd
brake light
Fig 3 Fig 4
Remove rear 3
rd
brake light wire
Remove factory
tire carrier bolts
Remove factory
tire carrier bolts