Aries Automotive 25009 User Manual
Page 2
4. Repeat steps 2 through 3 for Driver/left side installation.
5. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For gloss black finishes: Mild soap may be used to clean the Product.
Passenger side shown
Page 2 of 3
Remove (2)
Torque bolts
Fig 1
Fig 2
Fig 3
Remove dome
light wire
Fig 4
Remove swing
out safety strap
Remove
plastic cover
Flat tipped
screw driver
See also other documents in the category Aries Automotive For the car:
- 4049 (1 page)
- 4066 (2 pages)
- 4052 (2 pages)
- 4059 (2 pages)
- 4065 (2 pages)
- 4044 (1 page)
- 4080 (3 pages)
- 4042 (1 page)
- 4047 (1 page)
- 4068 (2 pages)
- 4083 (9 pages)
- 4057 (1 page)
- 4060 (2 pages)
- 4050-2 (4 pages)
- 4061 (2 pages)
- 4069 (2 pages)
- 4081 (3 pages)
- 4043 (2 pages)
- 4051-2 (4 pages)
- 5041 (1 page)
- 5052 (4 pages)
- 5047 (2 pages)
- 5053-2 (2 pages)
- 5057 (3 pages)
- 5042 (1 page)
- 5050 (2 pages)
- 5058 (7 pages)
- 5046 (2 pages)
- 5049 (2 pages)
- 5056 (2 pages)
- 3049 (2 pages)
- 3058 (1 page)
- 3062 (5 pages)
- 3045 (2 pages)
- 3057 (2 pages)
- 3042F (1 page)
- 3046 (2 pages)
- 3046F (3 pages)
- 2003-05 (2 pages)
- 3060 (2 pages)
- 3047 (2 pages)
- 3052 (2 pages)
- 3059 (4 pages)
- 3065 (8 pages)
- 3048 (1 page)