Aries Automotive 15009 User Manual

Page 2

4. Next select the factory mirror to be install onto your tubular door, slide the mirrors 2 mounting

tubes through the tubular doors mounting location followed by the (2) 3” x 1” Cylinder tubes slide
over the plastic mounting tubes of the mirror, secure the mirror with (2) 1 3/4" OD Flat Washers &
the (2) factory toque bolts as seen in (Fig 8), once aligned tighten torque bolts.

5. Repeat steps 2 through 4 for driver/left side installation.

6. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.

For gloss black finishes: Mild soap may be used to clean the Product.

Passenger side shown

Page 2 of 3

Remove (2)
Torque bolts

Fig 1

Fig 2

Fig 3

Remove (2)
Torque bolts

Remove dome
light wire

Fig 4

Remove swing
out safety strap