Aries Automotive 15200 User Manual
Aries Automotive For the car

INSTALLATION INSTRUCTIONS
FRONT BUMPER PART #1
5200
1976-2001 JEEP CJ/ YJ/ WRANGLER 2/4WD
PARTS LIST
(1) FRONT BUMPER
PROCEDURE
1. If vehicle is equipped with a stock front bumper, remove using a size 55 star socket.
2. Place Front Bumper over vehicles frame rails, as shown in figure 1.2, and secure using the same factory bolts and
washers. Hand tighten.
3. Adjust Front Bumper so that it is centered on the vehicle and tighten all hardware to complete installation.
Figure 1.1 - Front Assembly Exploded View
Figure 1.2 – Complete Front Assembly View
See also other documents in the category Aries Automotive For the car:
- 4049 (1 page)
- 4066 (2 pages)
- 4052 (2 pages)
- 4059 (2 pages)
- 4065 (2 pages)
- 4044 (1 page)
- 4080 (3 pages)
- 4042 (1 page)
- 4047 (1 page)
- 4068 (2 pages)
- 4083 (9 pages)
- 4057 (1 page)
- 4060 (2 pages)
- 4050-2 (4 pages)
- 4061 (2 pages)
- 4069 (2 pages)
- 4081 (3 pages)
- 4043 (2 pages)
- 4051-2 (4 pages)
- 5041 (1 page)
- 5052 (4 pages)
- 5047 (2 pages)
- 5053-2 (2 pages)
- 5057 (3 pages)
- 5042 (1 page)
- 5050 (2 pages)
- 5058 (7 pages)
- 5046 (2 pages)
- 5049 (2 pages)
- 5056 (2 pages)
- 3049 (2 pages)
- 3058 (1 page)
- 3062 (5 pages)
- 3045 (2 pages)
- 3057 (2 pages)
- 3042F (1 page)
- 3046 (2 pages)
- 3046F (3 pages)
- 2003-05 (2 pages)
- 3060 (2 pages)
- 3047 (2 pages)
- 3052 (2 pages)
- 3059 (4 pages)
- 3065 (8 pages)
- 3048 (1 page)