Aries Automotive 234013-2 - Manual

2000-12 CHEVROLET/GMC HD & 1500 CREW CAB 2/4WD Gas & Diesel Dually
4. Attach Side Tube to Front and Rear Brackets using (1) 12mm x 50mm bolt, (1) 14mm lock washer and (1) 14mm flat washer for
with (1) M12 - 1.75 x 120mm bolt, (1) 14mm split lock washer, and (1)14mm x 37mm OD flat washer. Hand Tighten.
(10) 14mm SPLIT LOCK WASHERS
(14) 14mm x 37mm OD FLAT WASHERS
SIDE BAR PART #234013/234013-2
(2) 12mm x 37mm OD FLAT WASHERS
each bracket, and hand tighten. Fasten Center Brace to Side Tube using (1) 10mm x 25mm bolt, (1) 10mm split lock washer,
(2) 10mm SPLIT LOCK WASHERS
(2) 10mm x 25mm HEX HEAD BOLTS
and 12mm x 22mm OD flat washer (used due to hole size on bracket). Adjust Side Tube so that it is level
manner as the front. Repeat for Center Brace, but insert (2) 16mm x 37mm OD spacer washers between Center
(4) 12mm x 50mm HEX HEAD BOLTS
(6) M12 - 1.75 x 120mm HEX HEAD BOLTS
(2) CENTER MOUNT BRACES
(2) REAR MOUNT BRACKETS
(2) FRONT MOUNT BRACKETS
(2) SIDE TUBES WITH STEPS
tighten all bolts to complete the driver-side assembly.
3. Attach and secure Rear Mount Bracket to underside of vehicles rear body mount as shown in Figure 1.4, in the same
2. From underneath truck, loosen and remove body mount bolts that run upward through mounts into floorboard.
Figure 1.1 – Driver-Side Full Assembly View
INSTALLATION INSTRUCTIONS
PARTS LIST
(note -these bolts only used for 2005 and earlier- use existing bolts for 2006 and up.
PROCEDURE
1. Begin installation by working on driver side of the vehicle (see Figures 1.1 - 1.4).
5. Repeat process for passenger side of vehicle to complete installation.
Attach and secure Front Mount Bracket to underside of vehicles front body mount (see Figure 1.2)
Brace and center body mount (see Figure 1.3).
and centered,