Aries Automotive S223005 - Manual

(888) 800-ARIES
INSTRUCTIONS
MOUNT KIT 223005 (1999-04 FORD F-250-350 SUPER CAB)
MOUNT KIT 223006 (1999-04 FORD F-250/350 CREW CAB)
QTY. CONTENTS
2 OVAL SIDE TUBES
4 MOUNT BRACKETS
12 5/16 –18 X 1.25 HEX BOLT
20 5/16 –FLAT WASHER
12 5/16 –LOCK WASHER
4 5/16-NUT CLIP
8 5/16 –18 HEX NUTS
8 1/4" BOLTS
8 1/4 FLAT WASHERS
8 1/4" LOCK WASHERS
8 1/4 “ HEX NUT
STEP 1 REMOVE CONTENTS FROM BOX AND VERIFY ALL PART ARE PRESENT. READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING.
STEP 2 INSTALL NUT CLIPS AS SHOWN (SEE FIGURE 1)
STEP 3 INSTALL MOUNT BRACKETS AS SHOWN USING 5/16” HARDWARE. HAND TIGHTEN (SEE FIGURE 2).
STEP 4 LINE BRACKET HOLES WITH THE THOSE OF THE OVAL TUBE. ASSEMBLE ¼” HARDWARE.
STEP 5 MAKE SURE STEP BAR AND BRACKETS ARE PROPERLY ALIGNED. TIGHTEN AND TORQUE 5/16” HARDWARE TO 19 FT-LBS. AND ¼”
HARDWARE TO 9 FT-LBS.
FIGURE 1 FIGURE 2
FINISH PROTECTION- ARIES PRODUCTS HAVE A HIGH FINISH THAT MUST BE MAINTAINED SUCH AS ANY OTHER HIGH FINISH PRODUCT
ON THE VEHICLE. PROTECT THE FINISH WITH A NON-ABRASIVE AUTOMOTIVE WAX. THE USE OF SOAP, POLISH, OR WAX THAT CONTAINS
ABRASIVES IS DETRIMENTAL, AS THE COMPOUNDS SCRATCH THE FINISH AND OPEN IT TO CORROSION.
DISCLAIMER- BUYER ASSUMES ALL RISK AND LIABILITY WHATSOEVER FROM THE INSTALLATION AND USE OF ARIES
PRODUCTS. ARIES PRODUCTS ARE SOLD AS DECORATIVE ACCESSORIES AND SHOULD NOT BE RELIED UPON AS
PROTECTION FOR THE VEHICLE OR OCCUPANTS IN THE EVENT OF A COLLISION OR ROLL OVER. ARIES AUTOMOTIVE
ASSUMES NO LIABILITY FOR INJURY, LOSS, INCIDENTAL OR CONSEQUENTIAL DAMAGES IN THE EVENT OF A COLLISION OR
ROLLOVER.