Aries Automotive 224013-2 - Manual (Page 2)

Page 2 of 3 10/4/2010)
4. Remove the passenger/Right side rear factory body bolt, from the list above select the
Passenger/Right side rear mounting bracket and secure it with factory Hex Bolt, Flat Washer,
Lock Washers (Fig 3) Shows bracket attached. Snug but do not tighten hardware at this time.
5. Select the Passenger/Right side sidebar and secure it to all mounting brackets with the (6)
10mm x 30mm hex bolts, (6) 10mm lock washer, and (6) 10mm flat washer. (Fig 4) shows side
bar attached to all brackets, Snug but do not tighten hardware at this time.
6. Level and align Sidebar properly; then tighten all hardware at this time.
7. Repeat steps 2-6 for Driver/left sidebar.
8. Do periodic inspections to the installation to make sure all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Product.
For gloss black finishes: Mild soap may be used to clean the Product.
FRONT PASSENGER SIDE
Fig 2 Fig 1
Fig 3
Install mounting
bracket with
Factory body Bolt &
washer. Shown with
bracket attached
Fig 4
Install mounting
bracket with
Factory body Bolt &
washer. Shown with
bracket attached
Install mounting
bracket with
Factory body Bolt &
washer. Shown with
bracket attached
(6)10mm hex bolts
(6)10mm flat washers
(6)10mm lock washers
Passenger rear