Aries Automotive 209005-2 - Manual (Page 3)

3” SIDEBAR WITH BEND
03-08 NISSAN MURANO
Page 2 of 3 6/26/12 Rev1 (DP)
8. Repeat steps 2 – 7 for passenger Sidebar installation.
9. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
Driver Side Installation Pictured
Fig 1 Fig 2A
(Fig 3) Driver side tied down loop
pictured from behind front tire
Fig 2B
Tie down loop
8mm x 60mm Hex Bolt
8mm Lock Washer
8mm Flat Washer
Fig 5
Front Front
Front
Front
12mm x 50mm Hex Bolt
12mm Lock Washer
(2) 12mm Flat Washers
12mm Hex Nut