Aries Automotive 203013-2 - Manual (Page 2)

Page 2 of 2 1/30/07 (AM)
Driver Side Rear Bracket Shown
10. Level and adjust Side Bar, then tighten all hardware at this time.
11. Repeat steps 2-10 for Passenger Side Bar.
12. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
(Driver Side Shown)
Remove these existing
bolts from front end of
pinch weld
(2) 6mm Hex Bolts,
(2) 6mm Nylock Nut, &
(4) 6mm Flat Washers
(1) 10mm Bolt Plate,
(1) 10mm Nylock Nut,
& (1) 10mm Flat
Washer.
(1) 12mm Hex Bolt,
(1) 12mm Lock Washer, &
(1) 12mm Flat Washers
Front 10mm Bolt Plate
Rear 12mm Bolt Plate
(1) 12mm Bolt Plate,
(1) 12mm Nylock Nut, &
(1) 12mm Flat Washers
(2) 8mm Hex Bolts,
(2) 8mm Lock Washers,
& (2) 8mm Flat Washers
Fig 1 Fig 2
Fig 3 Fig 4
Fig 5