Aries Automotive 203034-2 - Manual (Page 2)

2
FINISH PROTECTION- ARIES PRODUCTS HAVE A HIGH FINISH THAT MUST BE MAINTAINED SUCH AS ANY
OTHER HIGH FINISH PRODUCT ON THE VEHICLE. PROTECT THE FINISH WITH A NON-ABRASIVE
AUTOMOTIVE WAX. THE USE OF SOAP, POLISH, OR WAX THAT CONTAINS ABRASIVES IS DETRIMENTAL, AS
THE COMPOUNDS SCRATCH THE FINISH AND OPEN IT TO CORROSION.
DISCLAIMER- BUYER ASSUMES ALL RISK AND LIABILITY WHATSOEVER FROM THE INSTALLATION AND
USE OF ARIES PRODUCTS. ARIES PRODUCTS ARE SOLD AS DECORATIVE ACCESSORIES AND SHOULD NOT BE
RELIED UPON AS PROTECTION FOR THE VEHICLE OR OCCUPANTS IN THE EVENT OF A COLLISION OR ROLL
OVER. ARIES AUTOMOTIVE ASSUMES NO LIABILITY FOR INJURY, LOSS, INCIDENTAL OR CONSEQUENTIAL
DAMAGES IN THE EVENT OF A COLLISION OR ROLLOVER.
Aries Automotive
Accessories, Inc.
P.O. Box 1687
Lomita, CA 90717
Thank you for choosing Aries products
For Customer Service Support please
call: (888) 800-2743
STEP 5:
STEP 6:
STEP 7:
Place the sidebar up to the mounting brackets and bolt to the mounting
brackets using ½” x 1 ½” hex head bolt, flat and lock washer. Leave loose.
Make any final adjustments to the alignment of the sidebar and tighten all
bolts. Repeat for the opposite side.
You may need to periodically re-tighten the bolts.
Rear auxiliary
mounting bracket
½ x
1 ½”
hex
head
bolt
½” flat & lock
washers and hex
nuts
½ x
1 ½”
hex
head
bolt
Rear mounting
bracket
M12 x 100 mm
Hex head bolt
Front mounting
bracket