Aries Automotive 203032-2 - Manual (Page 2)

Page 2 of 3
10. Align holes on the Side Bar with holes on the Mounting Brackets. Attach Side Bar to Mounting Brackets with the
included (4) 8-1.25mm x 25mm Hex Head Bolt, (4) 8mm Flat Washers, and (4) 8mm Lock Washers (Figure 8).
Do not tighten at this time.
11. Level and adjust Side Bar, and then tighten all hardware at this time now.
12. Repeat Steps 2-11 for driver/left Sidebar
13. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
10mm x 30mm
Bolt Plate
(Bolt Plate)
10mm Nylock Nut
10mm Flat Washer
10mm x 35mm
Bolt Plate w/ Bent
(Bolt Plate w/ Bent)
10mm Nylock Nut
10mm Flat Washer
10mm x 25mm Hex
Head Bolts
10mm Nylock Nuts
10mm Flat Washers
Passenger Front
Mounting Bracket
Passenger Front
Support Bracket
Passenger Front Mounting Bracket Shown
Figure 1 Figure 2
Figure 4
Figure 3