Aries Automotive 2549 - Manual (Page 2)

Page 2 of 2 2/5/09 Rev 1(DP)
7. Hold the splash guard up into position and mark the location to cut the splash guard to clear
the Mounting Brackets, (Figure 3). IMPORTANT: To maintain strength, cut only what is
required to clear the Mounting Brackets. Once cut and trimmed for fit, reinstall the splash
guard using the factory hardware.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Sport Bar.
For gloss black finishes: Mild soap may be used to clean the Sport Bar.
Driver Side Installation Pictured
Use the Factory Bolts
(2) 12mm x 35mm Hex Bolts
(2) 12mm Lock Washers
(4) 12mm Flat Washers
(2) 12mm Hex Nuts
Fig 1
Fig 2
Fig 3
Front
Front
(1) 12mm x 40mm Hex Bolts
(1) 12mm Lock Washers
(1) 12mm Flat Washers
Cut out the sections
illustrated to clear the
Mounting Brackets