Aries Automotive B35-2006 - Manual (Page 2)

Page 2 of 3 4/23/10 (DP)
6. Select the driver side plastic splash guard and hold it up in position against the Frame Mounting
Bracket, (Figure 5). Mark the area that needs to be removed from the splash guard to clear the
Mounting Bracket. Check the location carefully and cut only the minimum amount of plastic from the
splash guard to clear the Bracket, (Figure 6). Once the slot has been checked for clearance, reinstall
the splash guard with the factory hardware. Repeat this step to reinstall the passenger side splash
guard.
7. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.
Drive Side Installation Pictured
Fig 3
Fig 1
Fig 2
Remove plastic center and
(2) side splash guards
Remove (3) factory
bumper bolts
Insert Bracket into opening
in bumper cover
(2) 12mm x 30mm Hex Bolts
(4) 12mm Flat Washers
(2) 12mm Lock Washers
(2) 12mm Hex Nuts
Pictured from behind bumper
Front
Front