Cutting instructions – Aries Automotive B35-6001 User Manual
Page 2
CUTTING INSTRUCTIONS
The template works best is placed on top side-of splash shield (the side towards the vehicle). Locate two-oval slots
that measure'3 10
x 20MM-". Gut out template and place over appropriate slots; Hold in place using masking tape.
Drill 6MM
holes at each of the small circles. Cut splash shield from each drilled hole to drilled hole. It may be
necessary to use a straight edge to ensure
a straight cut.
/ /
DRIVER SIDE
TOWARDS FRONT OF
SPLASH SHIELD
TOWARDS CENTER
PASSENGER
SIDE
EXISTING SLOT
TOWARDS FRONT OF
SPLASH SHIELD
TOWARDS CENTER
See also other documents in the category Aries Automotive For the car:
- 4049 (1 page)
- 4066 (2 pages)
- 4052 (2 pages)
- 4059 (2 pages)
- 4065 (2 pages)
- 4044 (1 page)
- 4080 (3 pages)
- 4042 (1 page)
- 4047 (1 page)
- 4068 (2 pages)
- 4083 (9 pages)
- 4057 (1 page)
- 4060 (2 pages)
- 4050-2 (4 pages)
- 4061 (2 pages)
- 4069 (2 pages)
- 4081 (3 pages)
- 4043 (2 pages)
- 4051-2 (4 pages)
- 5041 (1 page)
- 5052 (4 pages)
- 5047 (2 pages)
- 5053-2 (2 pages)
- 5057 (3 pages)
- 5042 (1 page)
- 5050 (2 pages)
- 5058 (7 pages)
- 5046 (2 pages)
- 5049 (2 pages)
- 5056 (2 pages)
- 3049 (2 pages)
- 3058 (1 page)
- 3062 (5 pages)
- 3045 (2 pages)
- 3057 (2 pages)
- 3042F (1 page)
- 3046 (2 pages)
- 3046F (3 pages)
- 2003-05 (2 pages)
- 3060 (2 pages)
- 3047 (2 pages)
- 3052 (2 pages)
- 3059 (4 pages)
- 3065 (8 pages)
- 3048 (1 page)