Aries Automotive B35-5007 - Manual (Page 2)

Page 2 of 3 2/11/11 (DP)
4. With assistance, hold the Bull Bar up to the outside of the Mounting Brackets. Attach the Bull Bar to the
Mounting Brackets with the included (4) 10mm x 35mm Hex Bolts, (8) 10mm Flat Washers, (4) 10mm
Lock Washers and (4) 10mm Hex Nuts, (Figure 9).
5. Align and adjust the Bull Bar and tighten all hardware. Reinstall the splash guard removed in Step 3,
(Figures 3 & 4).
6. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.
Driver Side Installation Pictured
Fig 1
Fig 2
Fig 3
Fig 4
Front
Passenger side tow hook
Remove clips
Remove splash guard (passenger
side pictured from below) Remove splash guard (driver
side pictured from below)
Remove clips
Front
Remove clips