Aries Automotive B35-4010 User Manual
Page 3
Page 3 of 3
12/05/08 Rev1
Fig 1
Hold the splash guard up to the mounting
area and mark location for cutting to clear
brackets. Cut only what is needed to allow
brackets to clear the splash guard.
Fig 3
Place Bolt Tab in
slotted hole with
plastic retainer
Splash guard area to trim off
Remove right & left side
factory bolts holding
crossbar on
Fig 2
Secure brackets with
(2) 12mm Hex bolts
(4) 12mm flat washers
(2) 12mm lock washers
(2) 12mm nuts
Shown with bracket attached
Bolt Tab in slotted
hole with plastic
retainer
Fig 3A
Fig 3B
Secure brackets with
(1) 12mm Hex bolt
(2) 12mm flat washers
(1) 12mm lock washer
(1) 12mm nut
Secure brackets with
(1) 10mm flat washer
(1) 10mm lock washer
(1) 10mm nut
Fig 5
Splash guard area to trim off
Secure Bull bar to each bracket with
(1) 12mmx 50mm Hex bolt
(1) 12mm flat washers
(1) 12mm lock washer
Fig 4
Passenger/right side shown
Driver/left side shown