Aries Automotive 2063-2 - Manual (Page 3)

Page 3 of 4 4-23-10 (DP)
Driver Side Installation Pictured
Fig 7
(Fig 3) Pictured from below vehicle Fig 4
(Fig 5) Viewed from behind bumper (Fig 6) Viewed from above-behind grille
Hold Bracket flat and
insert through opening
in back of bumper
Remove (3) factory
bumper bracket bolts
(outer bolts only)
Line up Bracket and bolt to bumper
bracket with (3) factory hex bolts
Pry up center of pin to
remove 2pc plastic fastener
This end
towards
Grille Guard
Front
Front Front
Front
Front
factory bumper bracket
(Fig 8) Apply Adhesive Backed Foam Tape to the back
of the Top Brackets to prevent damage during install