Aries Automotive 8044 User Manual

Page 3

GRILLE GUARD

2000-2004 MITSUBISHI MONTERO SPORT

Page 2 of 4 12-11-12 Rev1 (DP)

the Support Bracket to factory threaded hole with the factory hex bolt. Snug but do not tighten hardware
at this time. Repeat this Step to install the driver side Support Bracket.

6. Carefully unpack the Grille Guard. With assistance, line up the bottom mounting tabs on the Grille

Guard with the (2) previously installed Frame Mounting Brackets. Bolt the Grille Guard to the inside of
the Frame Mounting Brackets with the included (4) 12mm x 35mm Hex Bolts, (8) 12mm Flat Washers,
(4) 12mm Lock Washers and (4) 12mm Hex Nuts, (Figure 11). Do not tighten hardware at this time.

7. Push the Grille Guard back toward the vehicle and line up the (2) tabs on the Grille Guard with the (2)

Support Brackets. Bolt the tabs to the Support Brackets with the included (2) 8mm x 25mm Hex Bolts,
(4) 8mm Flat Washers, (2) 8mm Lock Washers and (2) 8mm Hex Nuts, (Figure 11). Do not tighten
hardware at this time.

8. Level and adjust the Grille Guard properly and tighten all hardware. IMPORTANT: Make sure that the

Support Bracket is in the center of the gap between the headlight and bumper before tightening
hardware.

9. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Grille Guard.
For gloss black finishes: Mild soap may be used to clean the Grille Guard.

Passenger Side Installation Pictured

(Fig 1) Passenger side pictured from under vehicle

Fig 2B

(Fig 3) Passenger side Bracket install pictured

10mm U-Bolt
(2) 10mm x 34mm Large Flat Washers
(2) 10mm Lock Washers
(2) 10mm Hex Nuts

Front

Fig 2A

10mm x 100mm Hex Bolt
10mm x 20mm STD Flat Washer