Aries Automotive 3053-2 - Manual

PARTS LIST:
1 Grille Guard 2 12mm x 100mm Hex Bolts
1 Driver/Left Mounting Bracket 8 12mm x 30mm Hex Head Bolts
1 Passenger/Right Mounting Bracket 20 12mm Flat Washers
1 Driver/Left Support Bracket 10 12mm Hex Nuts
1 Passenger/Right Support Bracket 10 12mm Lock washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. DO NOT ATTEMPT INSTALLATION ALONE;
PERSONAL INJURY OR DAMAGE TO THE TRUCK MAY RESULT.
2. Start with the driver side, locate and loosen the (1) factory hex nut, (outer position), securing the
bumper to the frame, as seen in figure (Fig 1A & 1B).
3. Position the driver side Mounting Bracket over the factory bolt and secure with the factory hex nut. Line
up the slot in the side of the Mounting Bracket with the factory hole through the frame, as seen in figure
(Fig 1A & 1B). Select the driver side Brace Bracket and position it up to the back side of the frame as
shown in (Fig 2). Check for clearance and trim the plastic spoiler as required to clear brackets. Secure
the Mounting Bracket and Brace Bracket to the frame at the upper mounting position with the included
(1) 12mm x 100mm hex bolt, (2) 12mm flat washers and (1) 12mm lock washer & (1) 12mm hex nut,
(Fig 2). Secure the brace bracket to the mounting bracket at the lower mounting position with (1) 12mm
x 30mm hex bolt, (2) 12mm flat washers, (1) 12mm lock washer & (1) 12mm hex nut. Snug but do not
tighten hardware at this time.
4. Repeat Steps 2 & 3 for passenger side Mounting Bracket and Brace Bracket installation. Snug but do
not tighten hardware at this time.
Page 1 of 2
INSTALLATION INSTRUCTIONS
2001-11 FORD RANGER XLT / EDGE 2/4WD
PART # 3053 / 3053-2
Driver Side
Mounting
Bracket Passenger
Side
Mounting
Bracket
Passenger
Side Brace
Bracket Driver Side
Brace Bracket