Snorkel MB26J User Manual
Page 26
2. Operation & Specifications
2 - 16
LONG-TERM STORAGE
PRESERVATION
1. Clean and touch up damaged paint surfaces.
2. Fill the hydraulic tank to operating level with the platform fully lowered. Fluid should be
visible on the tank dip stick.
3. Coat exposed portions of cylinder rods with a preservative such as multipurpose grease
and wrap with barrier material.
4. Coat all exposed un-painted metal surfaces with a light oil or other preservative.
5. Cover the machine with tarpaulin if possible. If this is not available it is advisable to cover
the mast and jib mount area as a minimum. This will prevent moisture from entering the
mast, battery and chassis areas.
Figure 3: Battery Disconnect
BATTERY DISCONNECT
IS LOCATED BEHIND
THE CONTROLLER.
BATTERIES
1. Disconnect the batteries at the quick connect plug and socket. This is located in the chassis
between the controller and the hydraulic tank.
2. Disconnect the battery leads and tape up the lead terminals to ensure insulation.
Better battery life and efficiency is achieved if the batteries are used consistently. It is
therefore recommended that the batteries are used elsewhere if the machine is to be unused
for an extended period (2 weeks or more).
!
!
RISK OF SERIOUS INJURY. Take particular care when handling
batteries. Acid spills can cause severe burns or blindness.
DO NOT store batteries close to naked flames or close to steel
fabrication areas.
W A R N I N G