Routine service, For more information, Specifications – Snorkel U Drive 25-sn1125+ User Manual
Page 12
12
ITEM
Platform Height
Maximum
Minimum
Platform Capacity
Stored Dimensions
Vertical Height
Width
Depth
Footprint (screw jacks only)
Width/Length
Footprint (wheels attached)
Width/Length
Weight-overall
Battery Box
Guardrail Height
Toe Board Height
System Voltage
DC Electric Power Source
Battery Charger
Maximum Hydraulic System
Pressure
Drive Speed
Raising Speed
2-12 Volt Battery, Grp. 22
60 Amp/Hrs., Min. Wt. 52 lbs. (23.6 kg)
120 VAC 60 Hz or 220 VAC 50 Hz
Output: 5 Amps, 24 Volts D.C.
2400 PSI (165 bar)
2 MPH/0.2MPH
22 Seconds
ROUTINE SERVICE
Use the following table as a guide for routine maintenance, refer to Service Manual for complete service
instructions.
SERVICE OPERATION
INTERVAL
MONTHLY
3 MONTHS
YEARLY
DAILY
OR
OR
OR
50 HRS.
125 HRS.
500 HRS.
Check bubble level accuracy
X
Check operation of outrigger interlocks
X
Check battery fluid level and charge battery
X
Check for peeling, faded or missing labels & replace
X
Check condition of control cable
X
Inspect mast assembly for bends, cracks or loose rivets
X
Check chassis and platform emergency stop switch operation
X
Check emergency lowering valve operation
X
Check casters for damage
X
Check hydraulic fluid level
X
Check cage and cage support fasteners for proper torque
X
Inspect and adjust sequence straps slack
X
Lubricate lift chains and sheaves
X
Change hydraulic fluid (ISO #46)
X
Check drive wheels for loose, missing or worn parts
X
Specifications*
069316-001
12/99 D
FOR MORE INFORMATION
Local Distributor:
TEL: (800) 926-5438 or (559) 891-5200
FAX: (559) 896-9012
PARTSFAX: (559) 896-9244
1775 Park St., Selma, CA 93662
U DRIVE 25
25 ft. (7.62 m)
15 in. (38 cm)
350 lbs. (159 kg)
79 in. (1.98 m)
29 in. (74 cm)
49 in. (1.24 m)
59 in. (1.5 m)/56 in. (1.42 m)
80.5 in. (2.1 m)/75 in. (1.9 m)
903 lbs. (409.6 kg)
94.5 lbs. (42.9 kg)
43.5 in. (1.1 m)
6 in. (152 mm)
*Specifications subject to change without notice. Meets or exceeds all
applicable requirements of OSHA and ANSI A92.6-1999.