Figure 1: deploying the outriggers – Snorkel TL33-sn1001-1946 User Manual
Page 4
4
Figure 2 : Upper Control Box
Figure 3 : Lower Control Box
The On/Off/
Emergency
Override Switch
is located on the
left side of the
Upper Control
Box.
To utilize the
Emergency
Override feature
turn and hold
the Switch to the
‘EMERGENCY’
position.
2
8
7
To operate the Toggle Switches above the Keyswitch
must be turned to the clockwise position - CHASSIS.
10
3
1
6
NOTES :
*
An alarm is located in the Upper Control Box. This will sound when Tilt Sensor is activated, and while this alarm is on only
the Emergency Override controls can be used. This alarm will also sound when an Outrigger Limit Switch opens.
To deploy the Outrigger
the Locking Pin should
be released using the
spring loaded clamp.
The Outrigger can then
be rotated until the
Outriggers Locking Pin
engages the lower slot.
Figure 1: Deploying the Outriggers
The Outrigger Locking Pin moves
further and strikes the limit switch
plunger when load is applied to
the Outrigger Jack.
Vertical load increases
as the Outrigger Jack is
screwed down forcing
the Locking Pin further
into the slot.
9
11
4
5