Snorkel S2632E-sn000000 - Manual (Page 20)

18 S1930E/S1932E/S2632E – 1360417
Inspection and Maintenance Schedule
• Charge Status (Yellow) – blinks until the batteries
are 80% charged and then remains solid from 80%
to 100% charge.
• Complete Charge (Green) – lights solid when the
batteries are fully charged.
• Fault (Red) – lights solid when there is a battery
fault and blinks when there is a charger fault.
7. Leave the battery charger plugged in until it shuts
itself off.
Note
If the charging cycle exceeds 16 hours without the
batteries being fully recharged, unplug the charger and
have the batteries checked.
8. After the battery charger turns itself off, it is not
necessary to immediately unplug the extension cord
from the battery charger. The charger will monitor the
charge state of the batteries and recharge them if the
voltage drops off.
9. Release the latch on each side of the battery trays and
remove the cover to access the batteries. Remove
the caps from each battery.
10. Visually check the battery fluid level making sure the
level is within 6 mm (¼″) of the bottom of the filler
neck inside each hole. If needed, add distilled water.
11. Tightly replace the caps on each battery and replace
and latch the battery tray doors.
Inspection and Maintenance Schedule
Caution
Frequency and extent of periodic examinations may
depend on national regulations.
The Complete Inspection consists of periodic visual
and operational checks, along with periodic minor
adjustments that assure proper performance. Daily
inspection will prevent abnormal wear and prolong the
life of all systems. The inspection and maintenance
schedule should be performed at the specified intervals
and after prolonged periods of storage before returning
the machine to service. Inspection and maintenance shall
be performed by personnel who are trained and familiar
with mechanical and electrical procedures.
Warning
Before performing preventative maintenance,
familiarize yourself with the operation of the machine.
Always block the elevating assembly whenever it is
necessary to perform maintenance while the platform
is elevated.
The daily preventative maintenance checklist has been
designed for machine service and maintenance. Please
photocopy the Daily Preventative Maintenance Checklist
and use the checklist when inspecting the machine.