Snorkel S2632E-sn000001 - Manual (Page 12)

10 S1930E/S1932E/S2632E – 1360417
System Function Inspection
System Function Inspection
Refer to “Controls and Indicators” on page 7 for the
locations of various controls and indicators.
Warning
STAND CLEAR of the work platform while performing
the following checks.
Before operating the machine, survey the work area
for surface hazards such as holes, drop-offs, bumps
and debris.
Check in ALL directions, including above the work
platform, for obstructions and electrical conductors.
1. Move the machine, if necessary, to an unobstructed
area to allow for full elevation.
2. Pull the Lower Control Emergency Stop Switch to the
ON position.
3. Pull the Upper Control Emergency Stop Switch to the
ON position.
4. Visually inspect the elevating assembly, lift cylinder,
and hoses for cracked welds and structural damage,
loose hardware, hydraulic leaks, loose wire
connections, and erratic operation. Check for missing
or loose parts.
5. Hold the ground operation switch upward. Test each
machine function from the lower control station (refer
to Figure 3).
6. Test the emergency lowering system for proper
operation.
7. Push the Lower Control Emergency Stop Button to
check for proper operation. All machine functions
should be disabled. Pull the Lower Control Emergency
Stop Button outward to resume.
8. Enter the platform and close the gate.
9. Check that the route is clear of obstacles (persons,
obstructions, debris), is level, and is capable of
supporting the wheel loads.
10. Test each machine function from the upper control
station by engaging the interlock and operating the
function controls (refer to Figure 4).
11. Push the Upper Control Emergency Stop Button to
check for proper operation. All machine functions
should be disabled. Pull the Upper Control Emergency
Stop Button outward to resume.