Snorkel PUSH10 - Manual (Page 10)

Pre-Operation Safety Inspection
8 PUSH6/PUSH8/PUSH10 – 0120843
Pre-Operation Safety Inspection
Note
Carefully read, understand and follow all safety rules,
operating instructions, labels and National Safety Instruc-
tions/Requirements. Perform the following steps each
day before use.
1. Open the tray and inspect for damage, fluid leaks or
missing parts.
2. Check the level of the hydraulic fluid with the platform
fully lowered. The fluid level must be within 6 mm (¼″)
of the top of the fill hole. Add recommended hydraulic
fluid if necessary. See “Specifications” on pages 16
to 18.
3. Check that the fluid level in the batteries is correct.
See “Battery Maintenance” on page 15.
4. Verify that the batteries are charged.
5. Check that the AC extension cord has been discon-
nected from the outlet on the side of the chassis.
6. Inspect the brakes on the rear castor wheels for
proper operation. Step down on the brake levers and
verify that the machine will not move.
7. Check that all guardrails are in place and all fasteners
are properly tightened.
8. Inspect the machine thoroughly for cracked welds
and structural damage, loose or missing hardware,
hydraulic leaks, damaged control cable and loose
wire connections.