Snorkel PUSH 10 PRO-sn01-000050+ANSI - Manual (Page 39)

Chapter 10 – Stowing and Transporting
0120843-ANSI PUSH PRO 6,8,10 35
Figure 10.4 – Side of Chassis
3. Remove all personnel, tools, materials, or other loose
objects from the platform.
4. Insert the straps through the fork lift points using cor-
rectly rated straps. Strap damage and/or failure can
result from the strap contacting the sharp corners of
the fork pocket.
5. Use spreader bars of sufficient length to keep the
straps, or cables from contacting the scissors struc-
ture or platform. Careful rigging of the spreaders is
required to prevent machine damage.
6. Adjust the position of the strap so the aerial platform
remains level when raised off the ground.
7. Use the hoist or crane to carefully raise and position
the aerial platform onto the transport vehicle.
Securing for Transport
Use the following procedure to secure the aerial platform
on the transport vehicle.
1. Chock the wheels.
2. Remove all personnel, tools, materials, or other loose
objects from the platform.
3. Properly stow the aerial platform.
4. Place the lower controls emergency stop switch in
the off position.
5. Turn the control selector switch off and remove the
Key.
Caution
Ratchets, winches, and come-alongs can produce
enough force to damage machine components. Do
not over tighten the straps or chains when securing
the aerial platform to the transport vehicle.
6. Use chains or straps to securely fasten the aerial
platform to the transport vehicle using the straps
through the fork lift pockets. Proper tie-down and
hauling is the responsibility of the carrier.
Fork lift Pockets / hoist points