Snorkel PUSH 10 PRO-sn01-000050+ANSI - Manual (Page 33)

Chapter 8 – Prestart Inspection
0120843-ANSI PUSH PRO 6,8,10 29
Prestart Inspection Checklist
Item Inspect For OK
Operator’s Manual In manual holder, all pages readable and intact
Electrical System
Battery fluid level Proper level
Battery terminals Clean, connectors tight
Battery charger Proper operation
Cables and wiring harness No wear or physical damage
Hydraulic System
Fluid level Fluid is within ¼″ (6mm) off the top of the fill hole with platform stowed
Hoses, tubes and fittings No leaks, all fittings tight
Casters / Tires Good condition, no damage/smooth movement
Manual Brakes Proper operation, no damage or deformation
Lower Control Station
Operating controls Proper operation
Emergency stop Shuts off lower controls/proper operation
Lowering alarm and interrupt Sounds when platform lowers/ proper operation
Pothole Protection Interlock Proper operation
Emergency Lowering Proper operation
Safety Prop No damage or deformation
Flashing Light Proper operation
Structures
Weldments – Chassis, platform, etc. Welds intact, no damage or deformation
Slide blocks In place, no damage or deformation
Fasteners In place, tight, and no damage
Upper Control Station
Guardrail system Welds intact, no damage or deformation
All fasteners in place, no loose or missing parts
Platform floor No damage or deformation
Clean to prevent slip and fall hazards
Entry gate Proper operation, no damage or deformation
Operating controls Proper operation/ raise and lower
Emergency stop Shuts off upper controls
Lowering alarm Sounds when platform lowers
Lowering delay Proper operation, limit switch delays lowering
Battery condition indicator Proper operation
Placards and Decals In place and readable