Snorkel Pop-Up Push 8 Eco - Manual (Page 10)

Page 9 of 25 POP-UP PUSH 8 ECO Operator’s Safety and Maintenance Handbook ( rev.0.0.1.0210)
Section 4
OPERATING INSTRUCTIONS
Daily checks
Prior to operating the POP-UP PUSH 8 ECO , the following items must be checked:
• Structure (e.g. damage, cracks,
corrosion, abrasion, welds,
connections)
• Platform (floor, rails)
• Castors (smooth movement, damage)
• Rear manual brakes
• Auto front brakes
• Hydraulic oil
• Oil leaks
• Battery condition
• Raise and lower functions (including
descent delay) *
• Emergency stop and lowering
functions
• Limit switch
• Safety decals
• Stabilisers (optional if POP-UP PUSH
8 ECO is fitted with auto brakes)
* The raise and lower functions can be tested by removing the upper control box
from its holder in the work platform and using the controls whilst at ground level.
( NOTE: unless in an emergency situation, this practice must not be employed
when a person is in the work platform).
If the above checks reveal malfunctions or damage on the POP-UP PUSH 8 ECO ,
then the machine must not be used until the problem is rectified. If in doubt, seek
further assistance from the manufacturer.
If safety decals are no longer legible or missing, please contact the manufacturer
for replacements.
The Daily Checks page in Section 7 of this handbook may be photocopied to
provide an aide memoir for operators when undertaking these important checks.
WARNING
BEFORE OPERATING YOUR POP-UP PUSH 8 ECO , YOU MUST ENSURE THAT
YOU HAVE BEEN ADEQUATELY TRAINED IN ITS USE AND HAVE FULLY READ
AND UNDERSTOOD THIS OPERATOR’S HANDBOOK, PAYING PARTICULAR
ATTENTION TO SECTION 3 - SAFETY RULES
Manoeuvring the platform
Manoeuvre the platform into position using both hands on the platform rails
as shown. Take care to avoid trapping hands or feet whilst manoeuvring the
platform.
Never manoeuvre the POP-UP PUSH 8 ECO whilst it is elevated or with a
person, tools or materials in the platform.