Snorkel PAM26-sn0001+ - Manual (Page 22)

Page16
December 2008 Instruction Manual
6.2.2 DC Control Panel
1 Voltage indicator
2 On/Off key
3 Fuse
4 Emergency stop switch
5 Up button
6 Down button
6.3 Installation of Power Plug
Put the power plug into the power socket at the job site
in accordance with the rated requirement.
Note: Prior to installation, the rating of the power
source must be confirmed.
6.4 How to use the control buttons
6.4.1 Before operating the machine, all circuit breakers and leakage breaker must be
in ―ON” position on the electrical box panel
6.4.2 The mobile elevating work platform has two sets of controls; one at the base of
the unit and the other on the work platform itself
6.4.3 On either control panels, press ―Up” button for lifting and press ―Down”
button for lowering the platform.
6.4.4 The platform will be raised or lowered so long as the appropriate button is
depressed. The platform will stop in position as soon as the button is released.
6.4.5 Emergency stop: A big mushroom-shaped button is provided at each control
panel for emergency stop. This should be used only when other means to stop the
platform moving fails. Reset the button by turning the knob in the direction shown by
the arrow. Do not pull the knob
Note: The lower controls is installed on the electrical box, control its key. The key
should be taken away if it is not in use so as to prevent the unauthorized personnel
from using it.
close
open
6.5 Emergency Operation
In the event of power cut-off or other
reasons and the platform fails to descend
using both the upper and lower controls, an
emergency device consisting of a release
valve located at the side of the chassis is
used to lower the platform. Turn the valve
counterclockwise and the platform will be
lowered slowly. Once the platform has
descended to its lowest position, the valve
should then be closed securely.
Note: The above shows the diagram of
the emergency release valve.
Socket Plug