Snorkel M2639J-sn350+ User Manual
Page 9
Page 3
3 S
AFETY
I
NSPECTION
Figure 2: Work Platform
3. S
AFETY
I
NSPECTION
This Safety Inspection shall be carried out by the owner immediately prior to
transporting this machine.
This Safety Inspection shall also be carried out by the user prior to use each day.
The procedure is to carry out the following 14 checks in order as follows.
1. Remove the rear chassis covers by means of the two top twist-locks and the two lift-
and-turn catches at the sides. The cover is removed by sliding it backwards and
upwards. Use the central handle provided.
2. Ensure that the mast and jib are fully lowered. Remove the hydraulic oil filler cap and
check that the hydraulic oil level is correct. Oil should be visible on the dip stick. Top up
as necessary using hydraulic oil Viscosity Grade ISO 46.
3. Inspect the chassis area for oil leaks, loose parts, frayed cables and hoses and
structural damage etc. Check that all cable connections to the solenoid valves are
intact.
4. Open the Inspection hatches on both sides of the upper mast cover. Check that the AC
Platform
Platform Controller
Elevating Assembly
Chassis Controls
Safety Drop-bar
Chassis
W A R N I N G
!
!
DO NOT use the work platform without safety drop-bar in place and
with the safety harness fitted.