Kinesis KB800MB-BT Freestyle2 Blue, Multichannel Bluetooth Keyboard for Mac - Manual (Page 4)

Optional Accessories
Other physical configurations are possible with optional accessories (see below). To purchase accessories, inquire with your dealer or visit www.kinesis.com.
VIP3™ Accessory Kit, AC820-blk. V-lifters with integrated palm supports provide three angles of adjustable tenting (5
○ , 10 ○ , and 15 ○ , instant and sturdy!).
These V-lifters must be used with the included palm supports. Includes a pair of palm pads (available separately as AC806PS-blk, see below).
V3™ Accessory Kit, AC730-blk. These three-angle V-lifters provide instantly-adjustable and sturdy tenting (5
○ , 10 ○ , and 15 ○ ) without palm supports. The V3
V-lifters do not require and will not work with Freestyle2 palm supports.
Ascent™ Accessory Kit, AC740-blk. Sturdy and incredibly versatile steel modules support adjustable tenting at 10
○ increments over a wide range of angles
(20-90 degrees). Each side may be tented differently. A rigid steel linking plate may be attached for fixed separation. Freely adjust the splay, or completely
separate the two sides. Optional Freestyle2 palm supports work at lower tenting angles.
Freestyle2 palm supports, AC806PS-blk. These are included with AC820-blk but may be ordered separately to use with KB800PB or with AC740-blk.
Includes gel-like, self adhesive, replaceable palm pads (covered with black lycra). Replacement palm pads (AC700PP-blk) may be purchased separately.
Warranty
A two-year limited warranty applies to the original purchaser of all Freestyle2 keyboards and accessories. For details visit www.kinesis.com and click the link
for “Support.”
Technical Support
Contact Kinesis Technical Support by email ([email protected]) or by phone (USA 425-402-8100). Staff is on hand 8:00am to 4:30pm Pacific time, M-F.
Please be prepared to provide the serial number of your keyboard, your purchase date, the computer model, and the operating system of your computer, as well
as the details of your question or problem.
Regulatory & Safety Information
FCC (United States)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation. Federal Communication Commission Interference Statement: This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures: 1) Reorient or relocate the receiving antenna. 2) Increase the separation between the equipment
and receiver. 3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4) Consult the dealer or an experienced radio/TV
technician for help. FCC Caution: Any changes or modifications not expressly approved by Kinesis could void your right to operate this equipment.
IMPORTANT NOTE - FCC Radiation Exposure Statement: The product complies with the US portable RF exposure limit set forth for an uncontrolled environment and are
safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or
set the device to lower output power if such function is available. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Industry Canada statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Radiation exposure statement: This product complies with the Canada portable RF exposure limit set forth for an uncontrolled environment and is safe for intended operation
as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower
output power if such function is available.
Déclaration d’exposition aux radiations: Le produit est conforme aux limites d'exposition pour les appareils portables RF pour les Etats-Unis et le Canada établies pour un
environnement non contrôlé. Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel. La réduction aux expositions RF peut être augmentée si l'appareil peut
être conservé aussi loin que possible du corps de l'utilisateur ou que le dispositif est réglé sur la puissance de sortie la plus faible si une telle fonction est disponible.
CE & RoHS compliance
This equipment has been tested and found to comply with CE requirements for standards EN 62479:2010 and EN 300 328 V1.8.1 (2012-06). It is also RoHS compliant.
Battery warning
Risk of explosion or personal injury if batteries are replaced by incorrect type, mutilated, or exposed to conducting materials, liquid, fire, or heat (above 54 ○ C or 130 ○ F). Do
not use or recharge damaged rechargeable batteries. Dispose of spent or damaged batteries according to local laws.
Disposal of WEEE in the EU
To ensure that electronic equipment is recycled in a manner that protects human health and the environment, it is the user’s responsibility to dispose of it by delivering to a
collection point designated for recycling electrical and electronic waste equipment. For more information please contact your local city office, your household waste disposal
service, or the seller from whom you purchased the product.
Trademarks and patents
Kinesis & Freestyle are registered trademarks and the Kinesis logo, Multichannel, Freestyle2, Freestyle2 Blue, Pivot Tether, VIP3, V3, Ascent,
and Kinesis Computer Ergonomics are trademarks of Kinesis Corporation. The Bluetooth® word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. IOS is a trademark or registered trademark of Cisco, Apple, Mac and OS X are registered trademarks of Apple Inc.
The Freestyle2 keyboard and accessory designs are protected under US patents 7,828,489, 8,289,684, 8,454,254 and RE43,485. Other patents
pending.
Kinesis Corporation
22030 20 th Avenue SE, Suite 102
Bothell, WA 98021 USA
www.kinesis.com [email protected] phone: 800-454-6374 (USA only) or 425-402-8100 (fax 425-402-8181)
Version 9-17-14