Road Armor 1994-2002 Dodge 2500,3500 Rear Bumper - Manual (Page 3)

STEP 4:
Installing Road Armor Bumper
• Install the first Road Armor frame bracket using
stock hardware. Refer to picture to determine how
the bracket mounts onto the frame. Hand tighten
all bolts to allow for adjustment once bumper is
on truck.
Picture 7
Repeat this step for the other side of the truck
• Insert one bolt plate into the bottom slot on the
bumper weld in brackets. Once bolt plate is insert-
ed into lower slots push one ½” push on retainer
to hold bolt plate onto bumper.
NOTE: We recommend only installing one bolt
plate on each side of the bumper to allow
for easy installation. The other plate will be
added to each side once bumper is on truck.
Picture 8
• It’s time to install your road armor bumper. Using
either a lift or a couple buddies, move the bumper
into place. The bolt plates that are already placed
into the bumper will line up with the slots in the
frame bracket. If needed use a tape measure to
align the bolt plates with proper spacing to make
mounting the bumper easier.
• Lift the bumper and slide the bolt plates into
the slots in the frame brackets. Once bolt plates
slide into to frame bracket slots insert one ½” flat
washer, ½” lock washer, and one ½” nut on each
bolt in each bolt plate. Hand tighten all hardware.
Picture 9
Repeat this step for the other side of the bum
per. Hand tighten all hardware.
• Once bumper is on truck insert another bolt plate
in the top slot of the frame bracket. Once bolt
plates slide into to frame bracket slots insert one
½” flat washer, ½” lock washer, and one ½” nut
on each bolt in each bolt plate. Hand tighten all
hardware.
Picture 10
Repeat this step for the other side of the bumper.
Hand tighten all hardware and prepare for final
adjustment.
• Make final adjustment to bumper and tighten all
hardware. Once bumper is fully adjusted attach
stain- less steel road armor logo to bumper with
supplied hardware.
• Enjoy your new Road Armor bumper