Road Armor 2015 Chevy 2500 Front Bumper - Manual (Page 2)

Suggested Lights Front Bumper: Rigid Dually series Vision X - Optimus Solo
Rear Bumper:
Rigid SR-M’s
License Plate Lights http://www.etrailer.com/Trailer-Lights/Optronics/LPL31CB.html
Verify you have all the hardware that was sent with the Bumper. The front Bumper re-
quires the following hardware (all are Grade 8)
(14) Single Bolt Plates
(2) 1/2” Push On Retainers
(14) 1/2” Flat Washers
(14) 1/2” Lock Washers
(14) 1/2” - 13 Hex Nuts
(1) Large logo
(1) Winch and Logo kit
(4) 1” Plastic plugs
The front bumper should have a part number for 315 plus the brackets labeled the same.
On to prepping the vehicle for installation. Park on a level surface, remove the license plate, and disconnect the battery. Now mask
off the front and rear of the body to avoid scratches or chips in the paint when uninstalling/installing the bumpers.
Step 1 & 2 Unplug fog lights/sensors and remove inner fender well bolts using a T15 bit
Step 1
Step 2