Road Armor 2009-2012 Ford F-150 Rear Bumper - Manual (Page 2)

STEP 1 : Make sure you have all necessary
tools and hardware.
Hardware Kit Includes : ( all Grade 8 )
( 8 ) Bolt Plates
( 8 ) 1/2” Flat Washers
( 8 ) 1/2” Lock Washers
( 8 ) 1/2” Hex Nuts
( 8 ) 1/2” Retaining Washers
( 8 ) Allen Head Bolt - Winch Hardware
( 1 ) Package of Road Armor Logo Hardware
Step 2 : Uninstall OEM Bumper
• Park on level surface and Disconnect Positive Bat-
tery Terminal.
• Unplug license plate light and if equipped remove
back up sensors.
Look at Picture 2 on how to remove reverse
sensors.
• Use a 10mm socket and ratchet to remove the
three bolts per side that hold the bumper on.
Picture 3
• Remove OEM bumper.
Note - there are two plastic tabs on the trailer hitch
cross member that will need to be pushed out to
remove the bumper.
Picture 4
• Remove license plate lights and backup sensor in-
serts from the bumper by pushing the plastic tabs
in on the back and pushing forward.
• Pictures 5 - 6
Step 3 : Install Road Armor Bumper
• Use a 21mm or 13/16” Socket and Ratchet to re-
move the three nuts per side that hold the trailer
hitch on.
Note : do one side at a time.
Picture 7
• Install Road Armor brackets using OEM hardware
and tighten.
Picture 8
• Install Bolt tabs into the bumper and use retain-
ing washers to keep the bolt tabs from falling
out.
Note : use a deep socket to help push the retaining
washers on.
Picture 9
1
2
4
3