beautypg.com

Warning, General operating procedures – Lull 644B Operation Manual User Manual

Page 26

background image

22

GENERAL OPERATING PROCEDURES

FOLLOW SAFE OPERATING
PROCEDURES

‰

ALWAYS check the load chart mounted in the
machine before lifting a load. Lift only within the
capacity of the machine as shown by the load
chart.

‰

Never tilt the frame when the boom is raised.

‰

Operate the controls smoothly–don't jerk the
hydraulic controls or steering wheel.

‰

Avoid sudden stops, starts, turns or changes in
direction.

‰

Never “cowboy” or play games with a forklift.

‰

Operate machine controls only while seated in the
operator's compartment.

‰

Never leave the operator's seat without first
lowering the boom to the ground, setting the park
brake, and placing transmission in NEUTRAL.

‰

DO NOT touch, lean on, or reach through the
boom, lift mechanism or transfer carriage areas.
DO NOT permit others to do so. Never climb on
the boom, lift mechanism or transfer carriage.

‰

STAY ALERT! Should something break, come
loose, or fail to operate on your machine, stop
work, shut down the machine and alert your
supervisor immediately.

REAR OSCILLATION LOCK SYSTEM

The Rear Oscillation Lock System provides safety and
stability by preventing the frame from rotating on the
rear axle.

The rear oscillation lock will be operational when any or
all of the following conditions apply:

1. When the boom angle exceeds 40°.

2. When the service brakes are applied.

3. If a system component fails.

When the boom angle is above 40°, the following
conditions apply:

1. Rear axle cylinder locks, preventing the frame

from rotating on the rear axle.

2. Transmission is disengaged.

3. Frame tilt function is disengaged.

Note: When the frame tilt function is disengaged, it

CANNOT be overridden by the operator unless
the boom angle is below 40°.

When the service brakes are depressed, the following
conditions apply:

1. Rear axle cylinder locks preventing the frame

from rotating on the rear axle.

2. The rear oscillation lock cylinder can be unlocked

by the frame tilt function when the boom is below
40 °.

Lower the boom or release the service brake to
deactivate the rear oscillation lock system. If the system
does not deactivate, a problem exists and must be
investigated.

WARNING

Keep all parts of your body inside the
operators compartment while operating the
rough terrain forklift.

ALWAYS LEVEL
MACHINE BEFORE
RAISING BOOM. NEVER
TILT FRAME WITH THE
BOOM RAISED.
MACHINE MAY TIP AND
CAUSE SERIOUS
PERSONAL INJURY OR
DEATH!

WARNING

ALWAYS LEVEL
MACHINE BEFORE
RAISING BOOM. NEVER
TILT FRAME WITH THE
BOOM RAISED.
MACHINE MAY TIP AND
CAUSE SERIOUS
PERSONAL INJURY OR
DEATH!

WARNING