MBW GPR77 - Manual (Page 11)

- 8 -
10. If the cable has been properly adjusted, and no
resistance is noticed, Skip to step 20.
11. Loosen the 10mm jam nut (item #9) on the shifter
housing.
12. Loosen the 10mm hex bolt (item #10) on the shifter
housing approximately 1/4”.
13. Loosen both hex nuts (item #1) securing the shifter
cable to the angle bracket (item #4).
14. Move the shifter lever (item #8) to the reverse
position and hold.
15. Move the actuator arm (item #6) all the way forward,
and then back off slightly.
16. Retighten the hex nuts (item #1) to the angle bracket
(item #4).
17. Move the shift lever (item #8) to the forward position.
18. Tighten the 10mm hex bolt (item #10) on the shifter
housing until resistance against the shifter lever
(item#8) is noticed then loosen slightly.
19. Tighten the 10mm jam nut (item #9).
20. Repeat steps 6-9. If the cable has been properly
adjusted and resistance is still noticed, the lever and
cable may need to be replaced.
21. Reconnect the engine deck to the baseplate using
the capscrews removed in step 3. (Do not tighten the
bolts.)
22. Secure the shifter lever to the handle using the
capscrews removed in step 4.
23. Reinstall the belt and adjust tension (Refer to Belt
Adjustment, page 6.).
24. Reinstall the beltguard.